On Sat, 02 Feb 2008 16:42:04 GMT, cz34n9 <cz34n9_nospam@[EMAIL PROTECTED]
> wrote:
>Page 20
>
>Locked: If the console is locked, then a key code will have to be
>entered. (6157 or 4257 or 2357).
>Note: The keycode is factory set as the console number in reverse.
>
>Page 21
>
>Locks: The last menu sets the record and setup locks.
I haven't looked into that yet. I'm not the lighting guy,
just helping him out. So can the thing be unlocked from
there, or...
>The record lock
>prevents the RECORD button from operating. The Setup lock locks the
>configuration system. IM****TANT: Once the Setup lock is set, the keycode
>is required to access the setup (configuration) parameters and change the
>locks. See top of previous page for keycode.
>
>Page 25
>
>Reset and Memory Clear:
>The following procedure causes the entire memory of the console to be
>cleared and factory default parameters to be installed. All programming
>and softpatches will be lost.
....do we have to clear the whole memory simply to unlock the
setup lock?
>This procedure may be used to clear the
>console to a known starting point prior to new programming or rental.
>1. Turn power switch off.
>2. Hold down the following buttons: Function 1, Function 2, Help, Change
>3. Turn power switch on while holding buttons.
>4. Release buttons after 10 seconds.
>Memory will be cleared after a few moments. A default softpatch will be
>installed.
>
>
>
>dh@[EMAIL PROTECTED]
wrote in news:gjgpp318ne2b11b1nkbu5fsbuaj4ejkpqv@[EMAIL PROTECTED]
>
>> On Fri, 25 Jan 2008 11:56:06 -0800 (PST), RickR
>> <info@[EMAIL PROTECTED]
> wrote:
>>
>>>On Jan 23, 11:18 pm, dh@[EMAIL PROTECTED]
wrote:
>>>> On Sun, 20 Jan 2008 13:52:16 -0800 (PST), RickR
>>>> <i...@[EMAIL PROTECTED]
> wrote:
>>>> >It looks like someone did lock the setup data, so the code must be
>>>> >entered to change any of it.
>>>>
>>>> How to enter it? The console doesn't have a numeric keypad
>>>> afaik, so how to enter the code?
>>>
>>>Get the manual,
>>>Read the manual,
>>>Know the manual,
>>>Become one with the board...
>>>
>>>This solves an amazing number of problems.
>>>
>>>RickR
>>
>> I couldn't find that part in the manual, or anything about
>> how to get rid of the locking problem.
|
