Page 20
Locked: If the console is locked, then a key code will have to be
entered. (6157 or 4257 or 2357).
Note: The keycode is factory set as the console number in reverse.
Page 21
Locks: The last menu sets the record and setup locks. The record lock
prevents the RECORD button from operating. The Setup lock locks the
configuration system. IM****TANT: Once the Setup lock is set, the keycode
is required to access the setup (configuration) parameters and change the
locks. See top of previous page for keycode.
Page 25
Reset and Memory Clear:
The following procedure causes the entire memory of the console to be
cleared and factory default parameters to be installed. All programming
and softpatches will be lost. This procedure may be used to clear the
console to a known starting point prior to new programming or rental.
1. Turn power switch off.
2. Hold down the following buttons: Function 1, Function 2, Help, Change
3. Turn power switch on while holding buttons.
4. Release buttons after 10 seconds.
Memory will be cleared after a few moments. A default softpatch will be
installed.
dh@[EMAIL PROTECTED]
wrote in news:gjgpp318ne2b11b1nkbu5fsbuaj4ejkpqv@[EMAIL PROTECTED]
> On Fri, 25 Jan 2008 11:56:06 -0800 (PST), RickR
> <info@[EMAIL PROTECTED]
> wrote:
>
>>On Jan 23, 11:18 pm, dh@[EMAIL PROTECTED]
wrote:
>>> On Sun, 20 Jan 2008 13:52:16 -0800 (PST), RickR
>>> <i...@[EMAIL PROTECTED]
> wrote:
>>> >It looks like someone did lock the setup data, so the code must be
>>> >entered to change any of it.
>>>
>>> How to enter it? The console doesn't have a numeric keypad
>>> afaik, so how to enter the code?
>>
>>Get the manual,
>>Read the manual,
>>Know the manual,
>>Become one with the board...
>>
>>This solves an amazing number of problems.
>>
>>RickR
>
> I couldn't find that part in the manual, or anything about
> how to get rid of the locking problem.
|
